VISIONMOUNT FLAT PANEL WALL MOUNT-VMAA18 - Wall mount for flat screen SANUS - Free user manual and instructions

USER MANUAL VISIONMOUNT FLAT PANEL WALL MOUNT-VMAA18 SANUS

Thank you for choosing the Sanus VMAA18 wall mount. The Sanus VMAA18 wall mount is designed to support a monitor sized up to 50 in. (127cm) and weighing up to 59 kg (130 lbs). The mount is adjustable; it will tilt +5^ to -15^ , swivel to ± 90^ , and roll ± 6^ .

WARNING

This product contains small items that could be a choking hazard if swallowed. Keep these items away from young children!

CAUTION

This product is designed for use in wood stud walls only! The wall must be capable of supporting up to five times the weight of the monitor and mount combined. If you have any doubts about the ability of the wall to support the monitor, contact Sanus Customer Service, or a qualified contractor.

CAUTION

Do not use this product for any purpose not explicitly specified by Sanus Systems. Improper installation or use may cause personal injury and/or property damage. If you do not understand these instructions, or if you have doubts about the safety of the installation, contact Sanus Customer Service. Sanus is not liable for injury or damage caused by incorrect installation or use.

Supplied Parts and Hardware

Before starting assembly verify all parts are included and undamaged. If any parts are missing or damaged do not return the item to your dealer; contact Sanus Customer Service Never use damaged parts!

[01] x 1

[03] x 2

[05] x 4

[04] x 2

[10] x 1

5/16 in.
[06] x 4

1/4-20
[07] x 4

[08] x 2

[16] x 2

[11] x 4

[12] x 4

[13] x 4

[14] x 4

[15] x 4

[23] x 4

M4

[18] x 4

M6

M8

[21] x 4

[22] x 4

[27] x 4

[24] x 4

[25] x 4

[26] x 4

[31] x 1
[32] x 1

[28] x 8

[29] x 4

[30] x 4

1: Attach Brackets to Monitor

2: Install Vise Assemblies

4: Install Wall Plate

NOTE

This product must only be used with wood studs spaced 30 - 40 cm (12 - 16 in.) on center.

NOTE

Do not overtighten the lag bolts [15]. Tighten only until the washer [06] is pulled firmly against the wall plate [01]. Periodic maintenance may be required.

5: Attach Arm to Wall Plate

HEAVY! You will need assistance with this step.

CAUTION

Avoid potential injuries or property damage! Ensure the safety bolts [08] are secure. Periodic maintenance may be required.

6: Install Preventer

7:Install Cable Management

8: Adjust Monitor Position

Adjust Up / Down Pitch

Extend or Retract Arm
CAUTION

Avoid potential injuries or property damage! Do not remove the adjustment nut [E]; tighten or loosen only as necessary for easy arm adjustment.